E-mon Energy Software Instrukcja Użytkownika Pobierz pdf (Strona 148)

Access Location

E-Mon Energy User Manual 14-11 E-MON

Initialize Recorder Button

As explained in the Recorder section of this manual, initializing a recorder is seldom done except for during

system startup or when adding a new recorder. When initializing, the parameters are set to the default, the

Hardware function by clicking on the Initialize Recorder button. A dialog window will open that allows you

to reset the Recorder to its factory default settings.

Figure 14.17 - Access Location Function – Initializing Recorder

Update Database Button

After scanning the device, the database may need to be updated to add or remove a device. The table column

will indicate a condition state of “new” or “bad.” If either of these conditions occurs, the Update Database

button will become available to access. The illustration below shows that Meter 4 is bad and we want to

remove it from the database since the meter is no longer needed for service.

Figure 14.18 - Access Location Function – Update Database

Columns Description

Recorder

This column displays the condition of the device. If the condition

states “Bad” or “Timeout,” there is a possible error in reading the

device and there may be a hardware or communication issue. If the

condition is “ok,” the hardware is functioning normally.

Meter 1 thru 8

This column displays the condition of the device. If the condition

states “Bad,” there is possible error with the device and may be a

hardware issue.

1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 222 223

Brak uwag

E-mon Energy Software Instrukcja Użytkownika Strona 148